A Hands-On Workshop for Constructing a Low-Field MRI System in Three Days

Access to Magnetic Resonance Imaging system assembly knowledge can be expanded by leveraging open-source hardware and software, simplified installation requirements, and collaborative training initiatives. To this end, we conducted a three-day workshop to construct an operational 0.27T MRI scanner. The workshop hosted 16 participants, including faculty, postdoctoral fellows, trainers, and students, who collaborated to build the scanner using open-source hardware and software components. Teams were designated to focus on various subsystems, including the magnet, passive shimming, radiofrequency (RF) coils, gradient coils, data acquisition, and reconstruction. Pre-workshop preparation involved simulation-based design processes and fabrication techniques, which incorporated configuring MaRCoS and PyPulseq libraries, CNC machining, and 3D printing. During the workshop, participants assembled an H-shaped magnet, which achieved a peak magnetic field strength of 0.269T. Passive shimming effectively reduced the field inhomogeneity from 3mT to 2mT. A 3 cm diameter RF solenoid was built and tuned to 11.4 MHz. The gradients exhibited less than 5% non-linearity in simulations and were fabricated by CNC machining copper plates. The assembled system was used to acquire a 2D spin echo of a water phantom. Following the workshop, the system was further optimized to scan relaxometry phantoms. A post-workshop survey was carried out, revealing over 87% satisfaction. The constructed scanner represents a valuable platform for educational initiatives, pulse sequence development, and preclinical research imaging efforts.