Comparison of the material quality of AlxIn1-xN (x ~ 0-0.50) films deposited on Si (100) and (111) by reactive RF sputtering

Here, we compare the material quality of AlxIn1-xN layers deposited on Si with different crystallographic orientations, (100) and (111), via radio-frequency (RF) sputtering. To modulate their Al content, the Al RF power was varied from 0 to 225 W, whereas the In RF power and deposition temperature were fixed at 30 W and 300oC, respectively. X-ray diffraction measurements reveal a c-axis-oriented wurtzite structure with no phase separation regardless of the Al content (x = 0-0.50), which increases with the Al power supply. The surface morphology of the AlxIn1-xN layers improves with increasing Al content and it is similar for samples grown on both Si substrates (the root-mean-square roughness decreases from 12 nm to 2.5 nm). Furthermore, from TEM images we notice a similar grain-like columnar morphology and defect density on samples deposited on both Si substrates under the same conditions. Simultaneously grown AlxIn1-xN-on-sapphire samples point to a residual n-type carrier concentration in the 1020-1021 cm-3 range. The optical band gap energy of these layers evolves from 1.75 eV to 2.56 eV with increasing Al content, consistent with the blue shift of their low-temperature photoluminescence. In general, the material quality of the AlxIn1-xN films on Si is similar for both crystallographic orientations. Nonetheless, samples deposited on sapphire show an improved structural and morphological characteristic likely due to the lower difference in lattice constants between the nitride and the sapphire substrate.