Spatially resolved observations of a split-band coronal type-II radio burst

Context. The origin of coronal type-II radio bursts and of their band-splitting are still not fully understood. Aims. To make progress in solving this problem on the basis of one extremely well observed solar eruptive event. Methods. The relative dynamics of multi-thermal eruptive plasmas, observed in detail by the SDO/AIA and of the harmonic type-II burst sources, observed by the NRH at ten frequencies from 445 to 151 MHz, is studied for the partially behind the limb event on 3 November 2010. Special attention is given to the band-splitting of the burst. Analysis is supplemented by investigation of coronal hard X-ray (HXR) sources observed by the RHESSI. Results. It is found that the flare impulsive phase was accompanied by the formation of a double coronal HXR source, whose upper part coincided with the hot (T~10 MK) eruptive plasma blob. The leading edge (LE) of the eruptive plasmas (T~1-2 MK) moved upward from the flare region with the speed of v=900-1400 km/s. The type II burst source initially appeared just above the LE apex and moved with the same speed and in the same direction. After about 20 s it started to move about twice faster, but still in the same direction. At any given moment the low frequency component (LFC) source of the splitted type-II burst was situated above the high frequency component (HFC) source, which in turn was situated above the LE. It is also found that at a given frequency the HFC source was located slightly closer to the photosphere than the LFC source. Conclusions. The shock wave, which could be responsible for the observed type-II radio burst, was initially driven by the multi-temperature eruptive plasmas, but later transformed to a freely propagating blast shock wave. The most preferable interpretation of the type-II burst splitting is that its LFC was emitted from the upstream region of the shock, whereas the HFC - from the downstream region.